產品品牌：ipega

產品型號：PG-IP077

 

本公司供應ipad/iphone音響充電座，品牌ipega，型號PG-IP077。質量保證，歡迎咨詢洽談。

Introduction（產品介紹）

  本產品是一款具備音響功能的多用充電座，具有多個充電接口，適用于iPad；iPad2；iPhone3G；4G主機。

  音響使用數字功放，2.0聲道大功率高音質輸出。

  帶3.5mm音頻輸入接口，支持其他外接音頻設備（如MP3，MP4等）。

  四個功能電子開關（音響開關機，音源輸入選擇，音量+，音量-），使用方便。

  支持iPad主機橫置及豎置擺放，便于您觀賞影音。

  帶 1PCS USB接口，可通過USB轉接線連接各種設備進行充電，

如：iPhone；iPod；MP3；MP4；藍牙耳機，手機等。

產品配件：  

  1PCS USB轉DC頭充電線

  1PCS 3.5mm音頻轉接線

User Manual（使用說明）

  1. 使用時,先通過USB充電線將產品接至iPad原裝電源適配器,再將iPad原裝電源適配器接至電源,此時本產品進入待機狀態。

  2. 將iPad或iPhone主機接入相應的放置槽內,當順利接入主機后,主機會有相應充電提示。

  3. 在主機進行充電時,若要使用音響功放,只需打開座充上的音響電源開關(電源指示燈為白色),便可做主機音響功放使用。

  4.iPad;iPhone主機使用音響功放時,可通過音源切換開關切換音源輸入(默認輸入音源為iPad,有對應LED指示當前輸入音源,iPad為藍燈,iPhone為綠燈),播放時還可隨時通過音量‘+；-’調控音量大小。

  5.當使用iPad橫置觀賞影音或iPhone不接入充電時,可通過音頻線連接到本產品音頻輸入接口時,為主機音響功放使用(當插入音頻接口時,自動切斷iPad與iPhone充電接口的音頻輸入,音源指示燈同時熄滅)。

電性參數：

輸入電壓： DC 5.1V

輸入電流： 2.1A

ntroduction:

This product is a multi -functional charger with speaker, with multiple charging port for iPad; iPad2; iPhone3G; 4G console.

Use of digital audio amplifier, 2.0 channel high-power high tone quality output.

With a 3.5mm audio input interface, support for other external audio device (such as MP3, MP4, etc.)

Four functional electronic switch (audio on-off switch, audio input selection, volume +, volume -), easy to use.

User could place Ipad transverse and vertical, allowing you to watch the video.

With 1pc USB interface, can connect USB cable for charging all kinds of devices, such as: iPhone; iPod; MP3; MP4; Bluetooth headsets, mobile phones.

 

Accessories:

   1pc USB to DC charging cable

   1pc 3.5mm audio adapter cable

User Manual:

1. When using, connect the iPad original power adapter to this product through the USB charge cable. Connect the iPad original power adapter to the power.This product will enter standby mode.

2. Put the iPad or iPhone console access the appropriate placement. When it is successfully connected to the console, console will show corresponding charging signal. 

3. When the console is in charge, simply open the sound power switch(Power indicator is white) to use the audio amplifier.

4. When iPad; iPhone console operate audio power amplifier, switch audio input by audio switch (default input source for the iPhone, it has a corresponding LED indication, iPad for the blue light, iPhone is the green light). When playing,  adjust the volume control at any time by '+;-'.

5. When watching video or using the iPad tap access to iPhone and is not charging, user could use the audio cable connect to the audio input interface of this product, used as the console audio amplifier (audio interface when inserted, automatically cut off the iPad and iPhone charging interface audio input, light sources while off).

 

Electrical Data:

Input voltage： DC 5.1V

Input current ： 2.1A